Pressure Relief Valve Sizing: UK Hydraulic Systems
A lot of people land on pressure relief valve sizing after a failure. Not always a dramatic one. Sometimes it's a hose that split on a telehandler, a manifold block that keeps weeping around a cartridge cavity, or a power pack that runs fine until a cold start...
Push Fit Connectors 6mm: Your Expert Selection Guide
You're usually looking at 6mm push fit connectors when time is tight and the job isn't happening on a clean bench. It's a machine down in a yard, a cramped cabinet on a production line, or a pilot air line routed through a mobile chassis that never...
Hydraulic Performance Optimization: A Practical UK Guide
Most hydraulic systems in the UK are working far harder than they need to. Average hydraulic system efficiency is estimated at only 22%, which means nearly 78% of input energy is lost through heat, friction, and pressure drops according to Advanced Science Research....
Hydraulic Maintenance Scheduling: Prevent Downtime, Cut
You already know the scene. A machine is booked solid, production is under pressure, and the hydraulic system that “was on the schedule” fails anyway. A hose lets go, a pump starts whining, oil temperature climbs, or a valve sticks at exactly the wrong time. The...
Practical Troubleshooting Methodology for Hydraulics
A machine has stopped in the middle of a job. The operator says it was “fine five minutes ago”. Production wants an answer straight away. Someone is already reaching for a relief valve, someone else wants to order a pump, and the fault still hasn't been defined...
Testing and Commissioning Hydraulic Systems: A UK Guide
A lot of hydraulic failures don't start with bad components. They start on the day of first startup, when a new installation is finally piped, wired and filled, and someone is tempted to prove it by switching it on too early. That's the moment when a small...
Hydraulic Installation Guidelines: A Practical Field Guide
The crate is open, the power pack is on the floor, and the parts list is clipped to the bench. This is the point where good installs separate themselves from expensive ones. A hydraulic system can look tidy at first fit and still fail on first pressure, or worse, fail...
Hydraulic Technical Support: Expert Solutions
A machine doesn't usually stop at a convenient time. It stops when the trailer is loaded, when the press is due to start, or when the baler is already behind schedule. The first sign might be a whining pump, a sluggish ram, oil heating up faster than normal, or a...
Oil Analysis for Hydraulics: A Practical 2026 Guide
A lot of teams are in the same position right now. The lab report has landed in your inbox. It shows a few values drifting the wrong way, the machine is still running, production wants it left alone, and nobody wants to pull a pump or drain a tank on a hunch....
How to Read Pump Curves a Practical UK Guide for 2026
You're usually not looking at a pump curve out of curiosity. You're looking at it because something on the machine isn't right. The actuator is slower than expected. The oil is running hotter than it should. A replacement pump with the “same”...